Instructions for use

GHOST ALIGNER

GHOST ALIGNER SCISSORS

B-FORM

Technical information

AISI 410–420 stainless steel scissors. The serrated blade on one side ensures a non-slip cut.

PRODUCT FOR PROFESSIONAL USE

Applications

  • Cutting and trimming the soft dental bite registration after thermoforming.

Sterilisation

  • Pre-clean the instruments using a high-quality ultrasonic cleaning solution that is pH-neutral and contains rust inhibitors. Using distilled water will provide additional protection against rust and discolouration.
  • Dry the joints thoroughly with compressed air and a dry towel.
  • Place the unpackaged instruments on the tray with the jaw open. Avoid contact between instruments.
  • Run the sterilisation cycle at 134 °C (275 °F) for 3 minutes (autoclave). Refer to the instructions for the specific make and model of instruments you are using.
  • Lubricate the joints.

NOTE: All pliers are made from AISI 410 and 420 stainless steel and are covered by a 1-year warranty from the date of purchase.

Type

These scissors are available in the following types:

STRAIGHT TIP

CURVED TIP

#115-0646 - Length 11,5 cm - 1 piece
UDI-DI = 8057509251121

#115-0647 - Length 11,5 cm - 1 piece
UDI-DI = 8057509251138

Symbols


Warnings

In the event of a serious accident, please contact:

  • BART MEDICAL S.R.L. - Telephone: +39 0544 523326 - E-mail: sales@bartmedical.com

Manufacturer

BART MEDICAL

BART MEDICAL S.R.L.
Viale Vincenzo Randi 118
48124 Ravenna (RA)
+39 0544 523326
sales@bartmedical.com
www.bartmedical.com

Support

For further information and technical support, please contact us by email at sales@bartmedical.com